LR3/Disco 3
Installation
1 .
Install the tie rod end, note the number of turns until adjacent to the locknut.
2 .
CAUTION: To prevent damage to the tie rods, use an additional wrench when loosening or
tightening the components.
Connect the tie-rod end ball joint.
Clean the component mating faces.
Install a new nut and tighten to 70 Nm (52 lb.ft).
3 .
Tighten the tie-rod locking nut.
Clean the component mating faces.
Tighten the nut to 55 Nm (40 lb.ft).
4 .
Install the front wheel.
Tighten the wheel nuts to 140 Nm (103 lb.ft).
5 .
Lower the vehicle.
6 .
Using only four wheel alignment equipment approved by Land Rover, check and adjust the wheel
alignment.