LR3/Disco 3
Installation
5 .
Remove the wiring harness.
1 .
Attach the wiring harness.
2 .
Install the steering wheel cover.
Secure with the clips.
3 .
Install the steering wheel switch.
Connect the electrical connector.
Tighten the Torx screws.
Repeat the above procedure for the other side.
4 .
CAUTION: Correct clockspring alignment can be found by viewing a yellow marker through the
window situated on the clockspring face. If the marker is not visible, carefully turn the clockspring. If
the turning force increases before the marker is visible, reverse the direction to avoid component
damage.
Carefully install the steering wheel, engage the clockspring and align to the column.
Tighten the bolt to 63 Nm (46 lb.ft).
5 .
Install the driver air bag module. For additional information, refer to
Driver Air Bag Module (76.74.01)
(Section 501-20)