LR3/Disco 3
Steering Wheel (57.61.01)
Removal
Published : Jun 24, 2004
1 .
Remove the driver air bag module. For additional information, refer to
Driver Air Bag Module
(76.74.01)
(Section 501-20)
2 .
CAUTION: Make sure the wheels are in the straight-ahead position. Failure to follow this
instruction may result in damage to the components.
NOTE :
Note the steering wheel to column alignment marks.
Remove the steering wheel.
Restrain the steering wheel and remove the bolt.
Disconnect the steering wheel switch electrical connector.
3 .
NOTE :
Do not disassemble further if the component is removed for access only.
Remove the steering wheel switch.
Remove the 2 Torx screws.
Disconnect the electrical connector.
Repeat the above procedure for the other side.
4 .
Remove the steering wheel cover.
Release the 4 clips.