LR3/Disco 3
Installation
5 .
Remove the steering column intermediate shaft.
Release the 2 grommets.
6 .
NOTE :
Do not disassemble further if the component is removed for access only.
NOTE :
Note the fitted position.
Remove the 2 intermediate shaft grommets.
1 .
Install the steering column intermediate shaft.
Install the grommets.
2 .
Connect the steering column intermediate shaft to the lower shaft.
Tighten the new bolt to 25 Nm (18 lb.ft).
3 .
Connect the steering column intermediate shaft to the steering column.
Install the special bolt and tighten the new nut to 22 Nm (16 lb.ft).
4 .
Install the driver side closing trim panel.
Connect the electrical connector.
Secure the clip.
Tighten the screws.
5 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-00)