LR3/Disco 3
Engine Oil Draining and Filling (12.60.05)
1 . Disconnect the battery ground cable.
Specifications
2 .
Raise and support the vehicle.
3 . Remove the engine undershield.
Engine Undershield (76.10.50)
4 . Remove the oil pan drain plug.
5 . Remove the oil filter.
6 . To install, reverse the removal procedure.
7 . Fill the engine with oil.
8 . Check and top-up the engine oil.
Published : Jul 9, 2004
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on
safety stands.
Position a container to collect the fluid.
Discard the oil drain plug seal.
Position a container to collect the fluid.
Discard the oil filter.
Lubricate the oil filter seal with clean engine oil and tighten to 18 Nm (13 lb.ft).
Install a new seal.
Tighten the drain plug to 25 Nm (18 lb.ft).