LR3/Disco 3
Installation
1 .
Clean all the crankshaft pulley mating faces.
2 .
Using the special tool, install the crankshaft front seal.
Lubricate the seal with clean engine oil.
3 .
Using the special tool, install the crankshaft pulley.
Lubricate the seal with clean engine oil.
Remove the special tool.
4 .
CAUTION: The screw thread in the crankshaft pulley must be cleaned out before installing a
new crankshaft pulley bolt.
Install, but do not tighten, a new crankshaft pulley bolt.
5 .
Tighten the crankshaft pulley bolt.
Install the special tool.
Tighten the bolt to 45 Nm (33 lb.ft).
Tighten the bolt a further 85 degrees.
Remove the special tool.