LR3/Disco 3
Valve Cover LH (12.29.43)
Removal
Published : Feb 9, 2005
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Remove the fuel rail. For additional information, refer to
Fuel Rail (19.60.04)
(Section 303-04)
3 .
Position the injector harness aside.
Release the 2 clips.
Disconnect the 3 fuel injector electrical connectors.
4 .
Disconnect the 3 electrical connectors.
Release the harness clip from the filler neck.
Noting the installed position of the Knock sensor electrical harness in relation to the oil
filler tube, remove and discard the cable tie.
5 .
CAUTION: Before disconnecting or removing the components, ensure the area around the joint
faces and connections are clean. Plug open connections to prevent contamination.
Remove the valve cover.
Remove the 3 bolts.
Remove the 3 studs.