LR3/Disco 3
Tighten the bolts to 45 Nm (33 lb.ft), then a further 60 degrees.
3 .
Lower the engine onto the mount.
Tighten the nut to 90 Nm (66 lb.ft).
4 .
Remove the engine support.
5 .
Install the steering column lower universal joint assembly.
Install new patchlock bolts and tighten to 25 Nm (18 lb.ft).
6 .
Secure the brake hose to the upper arm.
Tighten the bolt to 23 Nm (17 lb.ft).
7 .
Connect the upper arm and wheel knuckle.
Remove the cable tie securing the upper arm.
Install a new nut and tighten to 70 Nm (52 lb.ft).
8 .
Secure the stabilizer bar link.
Tighten the nut to 115 Nm (85 lb.ft).
9 .
Connect the height sensor link arm.
10 .
Install the upper suspension arm and brake line heat shields.
Install the bolts.
Install the nuts.
11 .
Install the engine compartment upper LH heat shield.
Install the screw.
12 .
Install the engine undershield. For additional information, refer to
Engine Undershield (76.10.50)
(Section 501-02)
13 .
Install the front wheel.
Tighten the wheel nuts to 140 Nm (103 lb.ft).