LR3/Disco 3
Flexplate (12.53.13)
Removal
Installation
Published : Jun 17, 2004
1 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
2 .
Remove the transmission.
3 .
NOTE :
Prevent the flexplate from rotating
Remove the torque converter flexplate.
Remove the 8 bolts.
1 .
NOTE :
Prevent the flexplate from rotating
Install the torque converter flexplate.
Clean the component mating faces.
Tighten the bolts evenly in 2 stages to the sequence shown.
Tighten the bolts to 15 Nm (11 lb ft).
Tighten the bolts to 110 Nm (81 lb.ft).