LR3/Disco 3
Installation
1 .
Clean the component mating faces.
2 .
Install the exhaust manifold.
Install the gasket/heat shield.
Tighten the heat shield bolt to 25 Nm (18 lb.ft).
Evenly and progressively, tighten the bolts in the sequence shown to 20 Nm (15 lb.ft).
3 .
NOTE :
The heatshield consists of 3 parts.
Install the upper suspension arm and brake line heat shields.
Install the bolts.
Install the nuts.
4 .
Install the fender splash shield. For additional information, refer to
Fender Splash Shield (76.10.48)
(Section 501-02)
5 .
Install the exhaust system. For additional information, refer to
Exhaust System (30.10.08)
(Section
309-00)
6 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-00)