LR3/Disco 3
Crankshaft Rear Seal with Retainer Plate (12.21.20)
Removal
NOTE :
Installation
Published : May 17, 2004
The crankshaft rear seal and retainer plate are supplied as an assembly and cannot be serviced separately.
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
3 .
Remove the CKP sensor ring. For additional information, refer to
Crankshaft Position (CKP) Sensor
Ring (18.30.14)
(Section 303-14)
4 .
Remove the crankshaft retainer plate.
Remove the 14 bolts.
1 .
CAUTION: Oil seals must be fitted dry.