LR3/Disco 3
CAUTION: Tighten the bolts securing the seal retainer to the cylinder block first.
Install the crankshaft retainer plate.
Clean the component mating faces.
Install the seal retainer with its protection sleeve onto the crankshaft.
Locate the seal retainer onto the sump flange.
Engage the seal retainer dowels with the cylinder block and lightly tighten 2 bolts on
opposite sides of the retainer.
Remove the seal protection sleeve.
Install remaining bolts and tighten all bolts evenly to 10 Nm (7 lb.ft).
2 .
Install the CKP sensor ring to the crankshaft. For additional information, refer to
Crankshaft Position
(CKP) Sensor Ring (18.30.14)
(Section 303-14)
3 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-00)