LR3/Disco 3
Oil Pump Screen and Pickup Tube (12.60.20)
Removal
Installation
Published : Jul 12, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
3 .
Remove the oil pan. For additional information, refer to
Oil Pan (12.60.44)
(Section 303-01)
4 .
Remove the oil pump screen and pickup tube.
Remove the bolt.
Remove and discard both O-ring seals.
Clean the seal contact area.
1 .
NOTE :
Lubricate new seals with clean engine oil.
Install the oil pump screen and pickup tube.
Clean the components.
Install new O-ring seals.
Tighten the bolt to 10 Nm (7 lb.ft).
2 .
Install the oil pan. For additional information, refer to
Oil Pan (12.60.44)
(Section 303-01)
3 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-00)