LR3/Disco 3
Position the coolant expansion tank, locate the spigot and lug.
Tighten the bolt to 10 Nm (7 lb.ft).
3 .
Install the vacuum pump.
Install the bolts and tighten to 10 Nm (7 lb.ft).
4 .
Install the power steering fluid reservoir.
Position and secure to mounting bracket.
5 .
Install the windshield washer reservoir filler neck.
Locate in clip.
6 .
Connect the coolant hoses to the expansion tank.
Secure with the clips.
7 .
Top up the coolant.
Remove the hose clamps.
Check and top up the coolant.
Install the reservoir filler cap.
8 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-00)
9 .
Start and run the engine at idle until the normal operating temperature is reached.
10 .
Switch the engine off and allow to cool.
11 .
Check and top up the coolant.