LR3/Disco 3
Coolant Expansion Tank (26.15.01)
Removal
Published : May 7, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
WARNING: Since injury such as scalding could be caused by escaping steam or coolant, do
not remove the filler cap from the coolant expansion tank while the system is hot.
CAUTION: Engine coolant will damage the paint finished surfaces. If spilt, immediately remove
the coolant and clean the area with water.
Clamp, then disconnect the hoses from the coolant expansion tank.
Position an absorbent cloth to collect fluid spillage.
Position a container to collect the fluid.
Release the 2 clips.
3 .
Release the washer reservoir filler neck from the coolant tank clip.
4 .
Release the power steering fluid reservoir and position aside.
Release the clip.
5 .
Move the vacuum pump aside for access.
Remove the 3 bolts.
Remove the remaining expansion tank bracket bolt.