LR3/Disco 3
Thermostat (26.45.01)
Removal
Installation
Published : May 11, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00 Charging System - General Information)
2 .
Remove the thermostat housing.
Position a container to collect the fluid.
Disconnect the coolant hoses from the thermostat housing.
Remove the 3 bolts.
Remove and discard the seal.
3 .
WARNING: Eye protection must be worn.
Remove the thermostat.
Position the thermostat housing in a vice.
Release and remove the thermostat.
1 .
Clean the thermostat cover and housing mating faces.
2 .
To install, reverse the removal procedure.
Install a new thermostat seal.