LR3/Disco 3
Installation
Use the special tools.
5 .
NOTE :
Do not disassemble further if the component is removed for access only.
Remove the viscous coupling.
Remove the 4 bolts.
1 .
Install the viscous coupling.
Clean the component mating faces.
Tighten the bolts to 10 Nm (7 lb.ft).
2 .
Install the cooling fan assembly.
Clean the component mating faces.
Tighten the cooling fan assembly to 65 Nm (48 lb.ft).
Connect the electrical connector.
3 .
Install the cooling fan shroud.
4 .
Install the air cleaner assembly. For additional information, refer to
Air Cleaner (19.10.01)
(Section
303-12)
5 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-00)