LR3/Disco 3
Cooling Fan Belt Tensioner (26.25.02)
Removal
Installation
Published : May 7, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Remove the viscous fan drive belt. For additional information, refer to
Cooling Fan Belt (26.25.01)
(Section 303-05)
3 .
Remove the viscous fan drive belt tensioner.
Remove the bolt.
4 .
NOTE :
Do not disassemble further if the component is removed for access only.
Remove the drive belt pulley.
Remove the bolt.
1 .
To install, reverse the removal procedure.
Tighten the pulley bolt to 25 Nm (18 lb.ft).
Tighten the tensioner bolt to 40 Nm (30 Ib.ft).
2 .
Install the viscous fan drive belt. For additional information, refer to
Cooling Fan Belt (26.25.01)
(Section 303-05)