LR3/Disco 3
Accessory Drive Belt Tensioner (86.10.06)
Removal
Installation
Published : May 6, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Remove the accessory drive belt. For additional information, refer to
Accessory Drive Belt (86.10.03)
(Section 303-05)
3 .
Remove the accessory drive belt tensioner.
Remove the bolt.
4 .
Remove the accessory drive belt tensioner pulley.
Remove the Torx bolt.
1 .
Install the accessory drive belt tensioner pulley.
Clean the components.
Tighten the bolt to 25 Nm (18 lb.ft).
2 .
Install the accessary drive belt tensioner.
Clean the components.
Tighten the bolt to 45 Nm (33 lb.ft).