LR3/Disco 3
Installation
Remove the crankcase vent oil separator drain tube seal prior to the removal of the crankcase vent
oil separator.
NOTE :
Using a suitable adhesive tape, protect the oil cooler.
Remove the crankcase vent oil separator.
Remove and discard the crankcase vent oil separator drain tube seal.
Remove and discard the crankcase vent oil separator housing seals.
1 .
Position the crankcase vent oil seperator, but do not fully install at this stage.
Clean the immediate area.
Install new crankcase vent oil separator housing seals.
Install a new crankcase vent oil separator drain tube seal.
2 .
Connect the FRP sensor electrical connector.
Attach the fuel charging wiring harness.
3 .
Install the crankcase vent oil separator.
4 .
Connect the fuel injection pump electrical connectors.
5 .
Install the glow plug wires.
6 .
Install the low-pressure fuel line.
Remove the blanking caps from the ports.
Connect the low-pressure fuel line.
Attach the low-pressure fuel line.
7 .
Install the new high-pressure fuel supply line.
Remove the blanking caps from the ports.
Install the new high-pressure fuel supply line, but do not tighten unions at this stage.
Stage 1: Tighten the high-pressure fuel supply line union at the fuel pump to 15 Nm (11
lb.ft).
Stage 2: Tighten the high-pressure fuel supply line union at the fuel injection diverter rail to
15 Nm (11 lb.ft).
