LR3/Disco 3
Stage 3: Tighten the high-pressure fuel supply line union at the fuel pump to 30 Nm (22
lb.ft).
Stage 4: Tighten the high-pressure fuel supply line union at the fuel injection diverter rail to
30 Nm (22 lb.ft).
8 .
Connect the low-pressure fuel lines.
Remove the blanking caps from the ports.
9 .
Connect the glow plug electrical connectors.
10 .
Install the breather pipes.
11 .
Install the oil filter element.
Clean the components.
Install a new O-ring seal.
Tighten the oil filter element cover to 25 Nm (18 lb.ft).
12 .
Connect the EOP sensor electrical connector.
13 .
Install the EGR coolant cross-over pipe.
Install the two retaining bolts.
Tighten to 13 Nm (10 lb.ft).
14 .
Connect both EGR coolant cross-over pipe hoses.
Remove the EGR coolant hose clamps.
15 .
Connect the low-pressure fuel lines.
Remove the blanking caps from the ports.
16 .
Install the intake air shutoff throttle. For additional information, refer to
Intake Air Shutoff Throttle
(19.70.32)
(Section 303-04)
17 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
18 .
Check and top-up the engine oil.