LR3/Disco 3
Camshaft Position (CMP) Sensor (18.30.24)
Removal
Installation
Published : Aug 12, 2005
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00 Charging System - General Information)
2 .
Remove the engine cover. For additional information, refer to
Engine Cover - 4.0L (12.30.50)
(Section 501-05 Interior Trim and Ornamentation)
3 .
Remove the CMP sensor.
Disconnect the electrical connector.
Remove the bolt.
1 .
To install, reverse the removal procedure.
Clean the component mating faces.
Lubricate a new O-ring seal with clean engine oil.
Tighten the bolt to 6 Nm (4 lb.ft)