LR3/Disco 3
Installation
Remove the 2 bolts.
5 .
Using the special tool, remove the catalyst monitor sensor.
Release the wiring harness.
Disconnect the electrical connector.
1 .
CAUTION: Make sure the anti-seize compound does not contact the catalyst monitor sensor
tip.
CAUTION: Make sure the catalyst monitor sensor wiring harness is not twisted more than 180
degrees and is not in contact with either the exhaust or driveshaft.
Using the special tool, install the catalyst monitor sensor.
Clean the components.
Apply an anti-seize compound to the thread of the sensor.
Tighten the catalyst monitor sensor to 45 Nm (33 lb.ft).
Connect the electrical connector.
Attach the wiring harness.
2 .
Install the heat shield.
Tighten the bolts to 10 Nm (7 lb.ft).
3 .
Position the RH catalytic converter to the exhaust manifold.
