LR3/Disco 3
Crankshaft Position (CKP) Sensor (18.30.12)
Removal
NOTE :
Installation
Published : Jun 30, 2004
The CKP sensor is located on the LH side of the torque converter housing.
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
3 .
Remove the exhaust system. For additional information, refer to
Exhaust System (30.10.08)
(Section
309-00)
4 .
CAUTION: Before the disconnection or removal of any components, ensure the area around
joint faces and connections are clean. Plug any open connections to prevent contamination.
Remove the CKP sensor.
Disconnect the electrical connector.
Remove the bolt.
1 .
To install, reverse the removal procedure.
Clean the component mating faces.
Tighten the Torx screw to 8 Nm (6 lb.ft).