LR3/Disco 3
Engine Coolant Temperature (ECT) Sensor (18.30.10)
Removal
Installation
Published : May 21, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Remove the throttle body gasket. For additional information, refer to
Throttle Body Gasket
(Section
303-04)
3 .
Remove the ECT sensor.
Position an absorbent cloth to collect fluid spillage.
Disconnect the electrical connector.
Remove and discard the O-ring seal.
1 .
To install, reverse the removal procedure.
Clean the components.
Tighten the ECT sensor to 18 Nm (13 lb.ft).
Top-up the coolant.