LR3/Disco 3
Knock Sensor (KS) RH (18.30.30)
Removal
Installation
Published : Jul 21, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Remove the intake manifold. For additional information, refer to
Intake Manifold (30.15.02)
(Section
303-01)
3 .
Remove the KS.
Disconnect the electrical connector.
Release the RH KS electrical connector retaining clip.
Remove the bolt.
1 .
To install, reverse the removal procedure.
Clean the component mating faces.
Tighten the bolt to 20 Nm (15 lb.ft).