LR3/Disco 3
Oil Temperature Sensor (12.60.65)
Removal
Installation
Published : Jun 23, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
3 .
Remove the engine undershield. For additional information, refer to
Engine Undershield (76.10.50)
(Section 501-02)
4 .
CAUTION: Before disconnecting or removing the components, ensure the area around the joint
faces and connections are clean. Plug open connections to prevent contamination.
Remove the oil temperature sensor.
Disconnect the electrical connector.
Position a container to collect spillage.
Remove and discard the O-ring seal.
1 .
NOTE :
Lubricate new seals with clean engine oil.
Install the oil temperature sensor.
Clean the component mating faces.
Install a new O-ring seal.
Tighten the oil temperature sensor to 20 Nm (15 lb.ft).
Connect the electrical connector.
2 .
Install the engine undershield. For additional information, refer to
Engine Undershield (76.10.50)