LR3/Disco 3
Installation
1 .
Install the throttle body.
Clean the component mating faces.
Install a new gasket.
Tighten the 4 bolts to 10 Nm (7 lb.ft).
2 .
Connect the coolant hoses to the throttle body.
Secure the throttle body hoses clips.
Remove the hose clamps from the throttle body hoses.
3 .
Install the TP sensor electrical connector.
4 .
Install the air intake resonator. For additional information, refer to (Section 303-12)
5 .
Install the engine cover. For additional information, refer to
Engine Cover - 4.0L (12.30.50)
(Section
501-05)
6 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-00)
7 .
Check and top-up the coolant.
8 .
Use T4 to re-calibrate a new TP sensor.