LR3/Disco 3
Engine Coolant Temperature (ECT) Sensor (18.30.10)
Removal
Installation
Published : May 21, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Remove the throttle body. For additional information, refer to
Throttle Body Gasket
(Section 303-04)
3 .
Remove the ECT sensor.
Position the engine gas recirculation (EGR) coolant hose aside for access.
Position an absorbent cloth to collect fluid spillage.
Disconnect the electrical connector.
Remove the sensor and discard the seal.
1 .
To install, reverse the removal procedure.
Clean the components.
2 .
Tighten the ECT sensor to 18 Nm (13 lb.ft).
3 .
Top-up the coolant.