LR3/Disco 3
Engine Oil Pressure (EOP) Sensor (12.60.50)
Removal
Installation
Published : Nov 24, 2004
1 .
CAUTION: Before the disconnection or removal of any components, ensure the area around
joint faces and connections are clean. Plug any open connections to prevent contamination.
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Remove the radiator access panel.
Remove the 4 bolts.
3 .
Remove the oil pressure sensor.
Disconnect the electrical connector.
Position a container to collect the fluid.
1 .
To install, reverse the removal procedure.
Tighten the oil pressure sensor to 12 Nm (9 lb.ft).
Tighten the M6 bolts to 10 Nm (7 lb.ft).
Tighten the M10 bolts to 45 Nm (33 lb.ft).
2 .
Check and top-up the engine oil.
