LR3/Disco 3
Fuel Temperature Sensor (19.22.08)
Removal
Installation
Published : May 21, 2004
1 .
Secure the hood in the service position.
Release the support struts.
2 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
3 .
Remove the engine cover. For additional information, refer to
Engine Cover - 4.4L (12.30.50)
(Section 501-05)
4 .
CAUTION: Always plug any open connections to prevent contamination.
Remove the fuel temperature sensor.
Disconnect the electrical connector.
Position an absorbent cloth to collect fluid spillage.
1 .
To install, reverse the removal procedure.
Clean the component mating faces.
Apply sealant to the sensor thread.
Tighten the sensor to 7 Nm (5 lb.ft).