LR3/Disco 3
Camshaft Position (CMP) Sensor (18.30.24)
Removal
Installation
Published : Jul 28, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Remove the LH exhaust gas recirculation (EGR) valve. For additional information, refer to
Exhaust
Gas Recirculation (EGR) Valve LH (17.45.16)
(Section 303-08)
3 .
Disconnect the CMP sensor electrical connector.
4 .
Remove and discard the CMP sensor.
Remove the CMP sensor retaining bolt.
1 .
NOTE :
Only turn the engine in the normal direction of rotation.
Turn the engine until one of the three webs on the back of the camshaft pulley is visible through the
CMP sensor housing.
Timing belt cover shown removed for clarity.
Use a mirror, to view the webs on the camshaft pulley through the CMP sensor locating
hole.