LR3/Disco 3
5 .
Install the new RH and LH high-pressure fuel supply lines.
Remove the blanking caps from the ports.
Loosely install the new high-pressure fuel supply lines.
Stage 1: Tighten the high-pressure fuel supply line union at the fuel injection supply
manifold to 15 Nm (11 lb.ft).
Stage 2: Tighten the high-pressure fuel supply line union at the fuel injection diverter rail to
15 Nm (11 lb.ft).
Stage 3: Tighten the high-pressure fuel supply line union at the fuel injection supply
manifold to 30 Nm (22 lb.ft).
Stage 4: Tighten the high-pressure fuel supply line union at the fuel injection diverter rail to
30 Nm (22 lb.ft).
6 .
Secure the high-pressure fuel supply lines.
Tighten the two retaining bolts to 10 Nm (7 lb.ft).
7 .
Install the EGR coolant cross-over pipe.
Install the two EGR coolant cross-over pipe retaining bolts.
Tighten to 13 Nm (10 lb.ft).
8 .
Connect both EGR coolant cross-over pipe hoses.
Remove the EGR coolant hose clamps.
9 .
Connect the low-pressure fuel lines.
Remove the blanking caps from the ports.
10 .
Install the engine cover. For additional information, refer to
Engine Cover - 2.7L Diesel (12.30.50)
(Section 501-05 Interior Trim and Ornamentation)
11 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00 Charging System - General Information)
12 .
Bleed the fuel system.
13 .
Check and top-up the coolant.