LR3/Disco 3
Oil Temperature Sensor (12.60.65)
Removal
Installation
Published : Jul 13, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Drain the engine oil. For additional information, refer to
Engine Oil Draining and Filling (12.60.05)
(Section 303-01)
3 .
CAUTION: Before disconnecting or removing the components, ensure the area around the joint
faces and connections are clean. Plug open connections to prevent contamination.
Remove the oil temperature sensor.
Disconnect the engine oil temperature sensor electrical connector.
Position a container to collect the oil spillage.
Remove and discard the O-ring seal.
1 .
NOTE :
Lubricate new seals with clean engine oil.
Install the oil temperature sensor.
Clean the component mating faces.
Install a new O-ring seal.
Tighten the oil temperature sensor to 20 Nm (15 lb.ft).
Connect the engine oil temperature sensor electrical connector.
2 .
Fill the engine with oil. For additional information, refer to
Engine Oil Draining and Filling (12.60.05)
(Section 303-01)
3 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-00)