LR3/Disco 3
Install new retaining nuts.
Tighten the nuts to 22 Nm (16 lb. ft).
Install the exhaust manifold heatshield retaining bolt.
Tighten the bolt to 10 Nm (7 lb.ft).
16 .
Attach the exhaust cross-over pipe to the LH exhaust manifold.
Install new retaining nuts.
Install the exhaust manifold heatshield retaining bolt.
Tighten the nuts to 22 Nm (16 lb. ft).
Tighten the bolts to 10 Nm (7 lb.ft).
17 .
Secure the exhaust cross-over pipe center support bracket.
Tighten the retaining bolts to 25 Nm (18 lb.ft).
18 .
Install the exhaust cross-over pipe RH support bracket.
Align the exhaust cross-over pipe support bracket assembly.
Tighten the retaining bolts to 25 Nm (18 lb.ft).
19 .
Install the exhaust cross-over pipe LH support bracket.
Tighten the retaining bolts to 25 Nm (18 lb.ft).
Attach the transmission wiring harness to the support bracket.
20 .
Install the exhaust heat shield.
21 .
Install the turbocharger support bracket.
Tighten the retaining nut and two bolts to 22 Nm (16 lb.ft).
22 .
Install the rear driveshaft. For additional information, refer to
Rear Driveshaft (47.15.03)
(Section
205-01)
23 .
Install the front driveshaft. For additional information, refer to
Front Driveshaft - 2.7L Diesel
(47.15.02)
(Section 205-01)
24 .
NOTE :
Do not tighten the locking nut at this stage.
Connect the selector cable to the transmission.
Engage the inner cable with the lever clamping bush.
Install the selector cable to its abutment bracket.
25 .
Adjust the selector cable. For additional information, refer to
Selector Lever Cable Adjustment
(44.30.04)
(Section 307-05)
26 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
