LR3/Disco 3
Clean the component mating faces.
Lubricate the components.
2 .
Install the pedals.
Install the return spring.
Tighten the nut and bolt to 45 Nm (33 lb.ft).
3 .
Install the clutch pedal pad.
4 .
Install the brake pedal pad.
5 .
Install the stoplamp switch.
6 .
Install the pedal assembly.
Tighten the nuts to 25 Nm (18 lb.ft).
7 .
Install the clutch master cylinder.
Tighten the nuts to 10 Nm (7 lb.ft).
Install the clevis pin.
8 .
Install the clutch pedal spring assister.
9 .
Secure the wiring harness.
Secure the clips.
Connect the electrical connector.
10 .
Install the brake pedal bracket.
Tighten the Torx bolt to 10 Nm (7 lb.ft).
Secure the wiring harness.
11 .
Install the instrument panel access panel.
Secure with the clips.
12 .
Install the closing trim panel.
Connect the electrical connector.
Secure the clip.
Tighten the screws.
13 .
Install the headlamp switch. For additional information, refer to
Headlamp Switch (86.65.09)
(Section 417-01)
14 .
Install the brake booster. For additional information, refer to
Brake Booster (70.50.01)
(Section 206-
07)