LR3/Disco 3
Clutch Slave Cylinder (33.35.01)
Removal
NOTE :
Published : May 10, 2004
The clutch release bearing is is included with the slave cylinder assembly.
1 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
2 .
Remove the transmission. For additional information, refer to
Transmission (37.20.02.99)
(Section
308-03)
3 .
CAUTION: Always plug any open connections to prevent contamination.
NOTE :
Position cloth to collect fluid spillage.
Remove the fluid pipe.
Remove the clip.
Remove the bolt.
Remove the clamp.
Remove and discard the O-ring seal.
4 .
Remove the clutch slave cylinder and release bearing assembly.
Remove the 3 bolts.