LR3/Disco 3
Output Shaft Speed (OSS) Sensor (37.16.30)
Removal
Installation
Published : Jun 16, 2004
1 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
2 .
If installed, remove the transmission undershield.
Remove the 6 bolts.
3 .
Remove the OSS sensor.
Disconnect the electrical connector.
Remove the Torx screw.
1 .
Install the OSS sensor.
Clean the component mating faces.
Tighten the Torx screw to 10 Nm (7 lb.ft).
Connect the electrical connector.
2 .
If installed, install the transmission undershield.
Tighten the bolts to 10 Nm (7 lb.ft).