LR3/Disco 3
High/Low Range Sensor (41.30.07)
Removal
Installation
Published : Aug 23, 2004
1 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
2 .
Remove the crossmember. For additional information, refer to
Transmission Support Crossmember
(76.10.09 or 76.10.92)
(Section 502-02)
3 .
CAUTION: To avoid damage to the joints or gaiters, do not allow the transmission to hang on
the driveshafts.
Remove the mode sensor.
Lower the rear of the transmission for access.
Disconnect the electrical connector.
Remove the 2 Torx bolts.
1 .
To install, reverse the removal procedure.
Clean the components.
Tighten the Torx bolts to 10 Nm (7 lb.ft).
2 .
Install the crossmember. For additional information, refer to
Transmission Support Crossmember
(76.10.09 or 76.10.92)
(Section 502-02)
3 .
Use T4 to re-calibrate a new mode sensor.
