LR3/Disco 3
Installation
5 .
NOTE :
Do not disassemble further if the component is removed for access only.
Remove the LH tail pipe.
Using 100-051, cut the tail pipe at the point indicated by a depression in the pipe.
6 .
Remove the RH tail pipe.
Using 100-051, cut the tail pipe at the point indicated by a depression in the pipe.
1 .
NOTE :
Do not tighten the retaining clamp at this stage.
Position the RH tail pipe to the muffler assembly.
Clean the components.
Install the retaining clamp.
2 .
NOTE :
Do not tighten the retaining clamp at this stage.
Position the LH tail pipe to the muffler assembly.
Clean the components.
Install the retaining clamp.
3 .
With assistance, install the muffler assembly.
Attach the exhaust hangers.
Install a new gasket.
Tighten the catalytic converter nuts and clamp to 48 Nm (35 lb.ft).