LR3/Disco 3
Connect the quick release connector.
Secure in the 2 clips.
8 .
Install the vent line.
Connect the quick release connector.
Secure in the 3 clips.
9 .
With assistance, install the fuel tank to the transmission jack.
10 .
Position the fuel tank to the vehicle.
11 .
Secure the purge line to the fuel tank.
Secure with the clips.
Install the adhesive pad.
12 .
Connect the electrical connector.
13 .
CAUTION: Note the rear bolt is fitted with 2 washers.
Install the fuel tank.
Tighten the bolts to 45 Nm (33 lb.ft).
14 .
Install the 2 emergency release cable clips.
15 .
Secure the parking brake emergency release cable.
Secure in the 4 clips.
16 .
Secure the fuel tank harness.
17 .
Connect the vent line.
18 .
Connect the fuel supply and purge lines.
19 .
CAUTION: Tighten the new tamper proof clip until the hexagon shears.
Connect the fuel filler neck.
Install a new retaining clip.
20 .
Install the fuel tank heat shield.
Tighten the bolts to 6 Nm (4 lb.ft).
Tighten the nuts to 3 Nm (2 lb.ft).