LR3/Disco 3
3 .
Connect the temperature sensor electrical connector.
4 .
Install the heater housing.
5 .
Passenger side: Install the heater housing to bulkhead Torx bolt and tighten to 6 Nm (4 lb.ft).
6 .
Driver side: Install the heater housing to bulkhead Torx bolt and tighten to 6 Nm (4 lb.ft).
7 .
Install the footwell ducts.
Tighten the Torx screws.
8 .
Connect the drain tubes to the heater housing.
9 .
Install the adaptor panels.
Tighten the nuts to 6 Nm (4 lb.ft).
10 .
Secure the A/C lines to the bulkhead.
Clean the components.
Install new O-ring seals.
Tighten the bolt to 6 Nm (4 lb.ft).
11 .
Secure the A/C lines to the body.
Tighten the nut to 6 Nm (4 lb.ft).
12 .
Connect the bulkhead heater hoses.
13 .
With assistance, install the instrument panel.
Tighten the Torx bolts to 25 Nm (18 lb.ft).
14 .
Install the instrument panel carrier to bulkhead Torx bolt and tighten to 25 Nm (18 lb.ft).
15 .
Install the plenum chamber panel. For additional information, refer to
Plenum Chamber (80.15.62)
(Section 412-01)
16 .
Secure the heater housing.
Tighten the screws.
17 .
Connect the steering column intermediate shaft.
Install the special bolt and tighten the new nut to 22 Nm (16 lb.ft).
18 .
Install the heater housing center ducts.
19 .
Connect the instrument panel center reinforcement fibre optic cables.
20 .
