LR3/Disco 3
Condenser Core (82.15.07)
Removal
NOTE :
Published : May 19, 2004
The receiver drier need only be changed under the following circumstances: There is dirt in the refrigerant circuit
( eg. compressor seizure ). The system is leaking and refrigerant has been lost to atmosphere. Refrigerant circuit
has been open more than 24 hours due to repair.
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Recover the A/C refrigerant. For additional information, refer to
Air Conditioning (A/C) System
Recovery, Evacuation and Charging (82.30.02)
(Section 412-00)
3 .
Disconnect the A/C pipes.
Remove the 2 bolts.
Discard the O-ring seals.
Install blanking caps to the exposed ports.
4 .
Remove the viscous fan drive coupling pulley. For additional information, refer to
Cooling Fan
(26.25.19)
(Section 303-03)
5 .
Remove the lower fan shroud.
Release 2 clips from the cooling fan lower shroud.
Release and remove the cooling fan lower shroud from the cooling pack.
