LR3/Disco 3
Air Conditioning (A/C) Pressure Transducer (82.20.38)
Removal
Installation
Published : Jun 15, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Recover the A/C refrigerant. For additional information, refer to
Air Conditioning (A/C) System
Recovery, Evacuation and Charging (82.30.02)
(Section 412-00)
3 .
CAUTION: Before disconnecting or removing the components, ensure the area around the joint
faces and connections are clean. Plug open connections to prevent contamination.
CAUTION: To prevent damage to components, use an additional wrench when loosening or
tightening unions.
Remove the A/C pressure transducer.
Disconnect the electrical connector.
Remove and discard the seal.
1 .
Install the A/C pressure transducer.
Clean the component mating faces.
Install a new seal.
Tighten the transducer to 10 Nm (7 lb.ft).
Connect the electrical connector.
2 .
Recharge the A/C system. For additional information, refer to
Air Conditioning (A/C) System
Recovery, Evacuation and Charging (82.30.02)
(Section 412-00)
3 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-00)
