LR3/Disco 3
Auxiliary Climate Control Assembly (82.26.22)
Removal
Published : Jul 1, 2004
WARNING: Since injury such as scalding could be caused by escaping steam or coolant, do not remove
the filler cap from the coolant expansion tank while the system is hot.
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Remove the LH C-pillar lower trim panel For additional information, refer to
C-Pillar Lower Trim
Panel (76.13.34)
(Section 501-05)
3 .
Evacuate the A/C system. For additional information, refer to
Air Conditioning (A/C) System
Recovery, Evacuation and Charging (82.30.02)
(Section 412-00)
4 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
5 .
Support the exhaust system. Release the center, left and right rear mountings.
6 .
Remove the exhaust heat shield.
Remove the 4 nuts.
7 .
Remove the spare wheel and tire.