LR3/Disco 3
Installation
4 .
NOTE :
Do not disassemble further if the component is removed for access only.
Remove the heater core, inlet and outlet pipes.
Release the 2 clips.
Discard the O-ring seals.
1 .
Connect the heater core inlet and outlet pipes.
Install the new O-ring seals.
Position and secure in the clips.
2 .
Install the heater core.
Install the heater core.
Secure in the 2 clips.
3 .
Install the TXV assembly.
Install new O-ring seals.
Install the bolts and tighten to 10 Nm (7 lb.ft).
Tighten the screws.
4 .
Install the climate control assembly. For additional information, refer to
Auxiliary Climate Control
Assembly (82.26.22)
(Section 412-03)