LR3/Disco 3
Installation
1 .
Install the battery positive cable.
Connect the battery positive cable.
Tighten the retaining nut to 10 Nm (7 lb.ft).
Connect the generator electrical connector.
2 .
Install the generator.
Tighten the 3 bolts to 48 Nm (35 lb.ft).
3 .
Install the generator splash shield.
4 .
Install the splash shield. For additional information, refer to
Fender Splash Shield (76.10.48)
(Section
501-02 Front End Body Panels)
5 .
Install the front wheel.
Tighten the wheel nuts to 140 Nm (103 lb.ft).
6 .
Install the accessory drive belt. For additional information, refer to
Accessory Drive Belt (86.10.03)
(Section 303-05B Accessory Drive - 4.4L)
7 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-00
Charging System - General Information)
8 .
Lower the vehicle.