LR3/Disco 3
3 .
Connect the HO2S electrical connectors.
4 .
Install the electrical harness bridge.
Tighten the bolts to 45 Nm (33 lb.ft).
5 .
Connect the breather electrical connector.
6 .
Connect the PCV electrical connector.
7 .
Connect the CMP sensor electrical connector.
Secure the clip.
8 .
Connect the cooling fan electrical connector.
Carefully secure the clips.
9 .
Connect the KS electrical connectors.
10 .
Connect the generator.
11 .
Connect the ECT sensor electrical connector.
12 .
Connect the MAF sensor electrical connector.
Secure the clip.
13 .
Connect the fuel injector electrical connectors.
Carefully secure the clips.
14 .
Connect the engine wiring harness.
Install the clips on the harness protective cover.
Connect and secure the electrical connectors.
15 .
Install the battery compartment side wall.
Secure the clips.
Install the battery positive cable and grommet.
16 .
Install the engine compartment upper heat shield.
Secure the clips.
Tighten the screw.
17 .
Install the fusebox main feed cable.
Install the bolt and tighten to 10 Nm (7 lb.ft).
18 .
Install the battery. For additional information, refer to
Battery (86.15.01)
(Section 414-01)