LR3/Disco 3
Installation
46 .
Remove the engine wiring harness.
1 .
Install the engine wiring harness.
2 .
Connect the HO2S electrical connectors.
Carefully secure the clips.
3 .
Install the purge valve.
Secure the electrical harness with the clip.
Tighten the bolt to 6 Nm (4 lb.ft).
Connect and secure the electrical connector.
4 .
Connect the starter motor.
5 .
Connect the oil temperature and oil pressure sensors.
6 .
Connect the generator electrical connector.
Secure the clips.
7 .
Connect the CKP sensor electrical connector.
8 .
Secure the air compressor electrical connector.
9 .
Install the A/C mounting bracket.
Tighten the bolts to 25 Nm (18 lb.ft).
10 .
Install the power steering pump and mounting bracket.
Clean the component mating faces.
Tighten the bolts to 25 Nm (18 lb.ft).
11 .
Secure the transmission cooler pipes into clips.
12 .
Install the A/C compressor.