LR3/Disco 3
Tighten the bolts to 25 Nm (18 lb.ft).
13 .
Install the accessory drive belt.
14 .
Install the upper suspension arm and brake line heat shields.
Tighten the nuts and bolts to 10 Nm (7 lb.ft).
15 .
Install the fender splash shield. For additional information, refer to
Fender Splash Shield (76.10.48)
(Section 501-02)
16 .
Install the splash shield.
17 .
Install the front wheel.
Tighten the nuts to 115 Nm (85 lb.ft).
18 .
Connect the cooling fan electrical connector.
19 .
Connect the cylinder head earth ground connector.
Tighten the bolt to 10 Nm (7 lb.ft).
20 .
Connect the EGR valve electrical connector.
21 .
Install both CMP sensors.
22 .
Connect the fuel temperature sensor electrical connector.
23 .
Connect the MAP sensor electrical connector.
24 .
Connect the KS.
25 .
Connect the ECT sensor electrical connector.
26 .
Connect the ignition coil-on-plug electrical connections.
Install the clips.
Repeat the above procedure for the other side.
27 .
Connect the fuel injector electrical connectors.
Install the clips.
Repeat the above procedure for the other side.
28 .
Connect the VCT oil solenoid electrical connector.
Repeat the above procedure for the other side.
29 .
Install the ignition coil-on-plug cover.